TJ Treat – AUTOMATIC PRETREATER

The next generation automatic pretreatment machine with digital setup and control

Consistency! Using a Power Sprayer to pretreat T-shirts is a practiced art, and no two people in your shop will spray the same way. TJ Treat will give you even and consistent pretreated garments…one after another, after another.

Pretreating can be a messy process, and when using a hand-held Power Sprayer you have to be far away from your DTG machine.

TJ Treat is a stand-alone machine, digitally controlled with touch screen, so it is clean and easy to operate, and pretreating can be done right next to your DTG machine.

Download Data Sheet

TJ Treat works with all pretreat solution brands for every direct-to- garment printer.
The length and speed of the spray can be easily adjusted using the touch screen, and your settings saved in presets. So if you only need to partially print the T-shirt, just spray part of the T-shirt, and recall your setup from the stored ones.

TJ Treat fully encloses the pretreat process. Because you don’t get overspray outside the Treat2, it can be positioned directly next to your DTG machine. Pretreating a T-shirt takes about six seconds. By moving the external feed hose from your pretreatment solution to a water container, you can quickly flush the hoses and nozzle clean.

An easy-access rear door lets you quickly and simply remove the spray nozzle to clean it. The spray compartment can be wiped clean in just a few seconds.

TJ Treat – Technical Informations

  • No need for external air compressor
  • Draw directly from your original pretreatment container
  • Pretreat up to 410 x 610 mm (16” wide x 24” long)
  • Youth T-Shirt plate included
  • Digitally adjustable spray length and speed
  • Digital memory for up to 10 setup
  • Length: 40” (102 cm)
  • Width: 24” (61 cm)
  • Height: 20” (51 cm)
  • Power Requirements: 110 or 220V, 5A, plugs into a regular outlet